Zortrax Inventure
Tips & Tricks
Share your tips&tricks for printing with Zortrax Inventure 3D printer here.
General Discussion
A place for general discussion about Zortrax Inventure 3D printer.
About the Zortrax Inventure category
[
Zortrax Inventure
]
(1)
Inventure 'staircase' layer shift issue at 45 degrees
[
Zortrax Inventure
]
(2)
Nozzle change for smaller layer thickness
[
Zortrax Inventure
]
(2)
Serious printing problems!
[
Zortrax Inventure
]
(2)
0.09mm layer height
[
Zortrax Inventure
]
(1)
Review of the Zortrax Inventure
[
General Discussion
]
(2)
Inventure-M300 Dual, Z-Suite differences
[
Zortrax Inventure
]
(3)
Spiderweb on prints
[
Zortrax Inventure
]
(6)
Zultra plus stuck on the build plate real hard
[
Zortrax Inventure
]
(4)
Inventure's persistent upper fan error
[
Zortrax Inventure
]
(2)
Material End Stop
[
Zortrax Inventure
]
(2)
Bad Layer Shifting - Help needed
[
Zortrax Inventure
]
(8)
Z-Support Plus?
[
General Discussion
]
(4)
No PCABS profile on Z-SUITE
[
Zortrax Inventure
]
(2)
Lighting moody but useless
[
Zortrax Inventure
]
(3)
Very disappointed with my Inventure - need some serious advice!
[
Zortrax Inventure
]
(4)
Firmware1.5 zsuite 2.12.2 problem
[
Zortrax Inventure
]
(1)
Layer Thickness option
[
Zortrax Inventure
]
(3)
What build plate to use?
[
Zortrax Inventure
]
(2)
Issue with the filament feed
[
Zortrax Inventure
]
(2)
Bed Adhesion Improvements
[
Zortrax Inventure
]
(5)
Stringy support material
[
Zortrax Inventure
]
(3)
Spool holder assembly
[
Zortrax Inventure
]
(2)
Support Material - no longer 'supported'?
[
Zortrax Inventure
]
(2)
Thanks for the firmware update!
[
Zortrax Inventure
]
(1)
Any method to refill Inventure cartridges
[
General Discussion
]
(4)
Cartrige knobs?
[
Zortrax Inventure
]
(2)
Print only with build material?
[
Zortrax Inventure
]
(6)
Refillable Cartridges?
[
Zortrax Inventure
]
(2)
DDS times and temp
[
Zortrax Inventure
]
(3)
next page →