Zortrax M200 Plus   General Discussion

About the General Discussion category (1)
New M200+ Printer problem (7)
M200 Plus wont Start (2)
M200 plus Terrible print quality (6)
0.3/0.6mm nozzles setup not possible (16)
Disassemble Extruder head for bearing access (3)
Endstop issue / Carriage Issue (2)
Adhérence plateau en verre (4)
No buzzer on the M200 Plus? (2)
Material Endstop False Detection (4)
M200+ removal of the covers to access to the X and Y motors (3)
Convert zcode to some other format (1)
New glass build plate for m200+ (4)
Gap between infill and inner wall (2)
Perimeter Adhesion/Spacing (8)
Stringing for Z-PLA Pro (4)
Bypass firmware check (3)
Firmware upgrade 1.2.0 (2)
Heat bed is not stable (5)
Power saving and notification sounds are missing on the M200 Plus? (12)
M200 PLUS thermocoupler-heater (4)
Availability of 0,3mm nozzle for M200 Plus (2)
Video Built-in-camera? (4)
M200 Heated Bed upgrade to M200 Plus (1)
video camera image quality (3)
Strong adhesion in Z-Suite 2.6.1 (6)
M200 Plus hotend and extruder exploring (8)
First experience with the M200 Plus. (14)
* Zortrax M200 Plus * (7)