Zortrax M200   General Discussion


About the General Discussion category (1)
Best Z-Suite so far (regarding QUALITY only) ( 2 3 ) (40)
Infill to % (2)
The cost of M200 spares (12)
Zortrax Thermocoupler cable is on fire (5)
M200 Heated Bed resistor spec needed (5)
Replacement small connector for build plate (8)
new user , i love the printer but have some problems/concerns (6)
Why does dragon have a bad case of acne? (19)
Warping why not? (6)
Temperature of hotend when loading/unloading filament (2)
3D Model of Zortrax M200 (7)
Toshiba FlashAir on Zortrax M200 ( 2 3 4 ) (64)
Difference between Z ultrat and plus? (1)
Z-PHA in M200 (not Plus) (1)
Availability of 0.3mm and 0.6mm nozzles (2)
Emissions Study Using Zortrax M200 and Filaments (2)
Ribbon Cable - Connector mirror question. (1)
Where to order extruder PCB in USA? (5)
Availability of 0,3mm nozzle for M200 (2)
Fan plug (2)
Newer type of Z-ABS question (3)
advise on enclosure for M200 (4)
Comparative table of Z-materials (8)
diameter of the nozzle (9)
Z-PLA PRO Performance (3)
remove excess material from nozzle using tweezers and press the button to resume (3)
Best materials for high temperature? (4)
Quality of surface under support (7)
Hotend v1 vs. V2 - whether I need additional black wire? (4)