According to page 18 on the manual, the printing platform must be removed and cables disconnected. Then proceed to remove the printed part from the base.
Do you actually do this or do you try to get the part out without removing the platform base?
I only take it out to clean it, never take it out to take the print off , but make shore you use the putty knife to take it off
I take mine out after every print, that way I am not putting any stress on the axis etc. Unplugging and replugging connectors has not been an issue even after many many prints
David
Not on small prints.
Always on big prints, specially when Ultrat is used. Sticks like was epoxied to the platform!
Would not be great to have some sort of automatic connector (like 'Apple Magsafe' ) instead of un/plugging the cables by hand ? :-D
Would not be great to have some sort of automatic connector (like 'Apple Magsafe' ) instead of un/plugging the cables by hand ? :-D
+1!!!