I would like to ask a question to you experts in 3D printing / Zortrax ... :) :)
A jeweler (friend of mine) asked me to create a mold/prototype of a ring… I still don’t have the Zortrax so I wanted ask your opinion on the feasibilities … if any of you want to try to print it … What do you think? Thanks!
Here we go!
It was easy to print, but hard for me to take good photos… :rolleyes:
I removed the support only by knife.
Layer thickness: 0,09mm
Material: Z-Ultra
Print time: 16 min
Could you also print this part with your sharebot to compare the both prints?
273
274
275
276
I have no words! you have been a myth!
I can’t wait to be part of the forum with my M200! Thanks!
I'm trying this right now with a different approach.. Tilting model 45 degrees and going full 80 support.. I'll post pics when done..
Thanks Kyle!! :D
Didn't work out too well. Too much support on a very small piece..
Can you post images?
Didn't work out too well. Too much support on a very small piece..
No.. It broke into a pile of pieces.. Already threw it away..
Here's my print ... what do you think?