I guess nobody noticed because it’s barely used but :
I wanted to switch the light off, so I use the settings and switched it off.
But then, at my next print, the light was back on. I didn’t pay attention until I saw it on my observation webcam but it was too late, I started the print.
I don’t know anything about programming but :
Would it be possible to keep the last parameter (on or off) after switch off the printer ?
That would be practical.
Thanks
PS : I told you, it’s not important. Just a small matter.
[quote name=pilou74]I guess nobody noticed because it’s barely used but :
I wanted to switch the light off, so I use the settings and switched it off.
But then, at my next print, the light was back on. I didn’t pay attention until I saw it on my observation webcam but it was too late, I started the print.
I don’t know anything about programming but :
Would it be possible to keep the last parameter (on or off) after switch off the printer ?
That would be practical.
Thanks
PS : I told you, it’s not important. Just a small matter.
[/quote]
When possible I would like to see a manual light on on at any time. When I start a print I want the light on but when I go to bed I don’t need it on.
I believe Martin mentioned at one time that the lights are under software control and eventually we will be able to choose color, so I assume “off” will be possible as well.