Outer wall adhesion issues

Zortrax M200 Plus
5

Hi,

I do have the same problem. Z-Suite 2.10.3.0, Firmware 1.4.0.
Photos from Z-HIPS and Z-ASA pro (Piranhas from YouMagine) attached but also seen with Z-ABS (own design).

Z-ASA_pro_FJIMG_20190813_233810s
Z-ASA_pro_FJIMG_20190813_233810s1200×900 277 KB
Z-ASA_pro_FJIMG_20190813_233847_s
Z-ASA_pro_FJIMG_20190813_233847_s1200×900 251 KB
Z-ASA_pro_FJIMG_20190813_233907s
Z-ASA_pro_FJIMG_20190813_233907s1200×900 166 KB
Z-HIPS_FJIMG_20190813_162630s
Z-HIPS_FJIMG_20190813_162630s1200×900 155 KB
Z-HIPS_FJIMG_20190813_162647s
Z-HIPS_FJIMG_20190813_162647s1200×900 160 KB
Z-ASA pro 5x Piranha Fish.zcodex (5.7 MB)
Z-HIPS 5x Piranha Fish.zcodex (5.7 MB)