Prints failing on one side

Hey guys and gals,

I was wondering if somebody has an idea why my prints are failing on one side of the build plate, I changed the nozzle with a clean one, I thought it was the extruded motor cleaned that, it wasn’t that dirty to be honest, ran some prints in the middle of the plate all worked fine! I’m worried it might bet he extruded cable.

Really open to any suggestions, I’ll post some photos

Here are some photos, the big print failed after 29 hours :frowning:

I think I have figured it out, the heater and thermocoupler  screws were loose, tightened those and I'm doing a test print now, fingers crossed  :unsure: