Raft with overhangs

Zortrax M200 General Discussion
#1

Hi comunity,

What do you think about this zcode in attached picture.

Am I asking for troubles? Did it try anyone?

Thanks

Adam

#2

Not sure if I've done it on the M200 yet, but the Up can do this - the excess raft just air-prints into space and the print itself is OK.

#3

I think you will be fine I have dun that but not so extreme, run it and let us know nothing ventured nothing gained 

#4

Hi,

Definetely going to try it, I just don’t want to damage the printer. I will stay close to a printer just in case.

Thanks