Too big for Zortrax ?

Hello everyone,

I live in Belgium and I do not speak good English. This is a translation from the French : sorry for bad grammar and errors!

I read the forums every day because I want to buy a Zortrax soon.

For the moment, I use a lot Witbox which prints only PLA.

I would try the ABS and other new materials with M200.

Could someone tell me if the object (see stl file below : Attachment 562 not found. ) may be printed because I think it is too big for the plate of the Zortrax.

Is it possible to tell me printing time with the settings I use in Cura (see pdf file with the drawing and print settings : Attachment 563 not found.).

It is not necessary to print but simply open the file in Z-suite and register of the same parameters.

In advance thank you for this service

Axel

here's what is required ... :D

Schermata_2014_12_15_alle_15_28_53.png

Hello,

It fits diagonally and ... ook, someone else was faster :)

Thank you for the service and speed ! :)

How long to print ? With my settings ?

How is printed inside ?

Thank you for the service and speed ! :) How long to print ? With my settings ?How is printed inside ?

5hrs and 34 minutes at .19 with medium infil. Look at the pic azzoni screenshoted top right hand corner

Ok! I do not know yet Z-suite !

Here the orientation of the infill with Cura : Attachment 564 not found.

How this is printed on the Zortrax?

 

Big thank you again!

Here the orientation of the infill with Cura : attachicon.gifSans titre 3.pdf

How this is printed on the Zortrax?

 

very similar

wow at last someone from belgium im from antwerp

Why do you think there is nobody from belgium ? ;)

Location Beringen. And I believe I'm old enough to say that's belgium.

Welcome

maybe someday we can meet and talk about our zortrax 

Yeah, why not !

dirkpuntjeruttenapenstaartjexedupuntjebe