onap
May 26, 2016, 11:18am
#1
Hello all,
During the M200 maintenance I noticed that the 4 screws between the Z ballscrew and the platform support are not tightened and so have backlash in Z direction.
Is it normal. (I suppose not :-) )
See on video (with sound):
https://youtu.be/-d4rTEhanLU
Thanks
GBru
May 26, 2016, 12:16pm
#2
Yes, it's normal. Mine had a sticker warning not to tighten.
It prevents binding, any backlash that does exist is taken up by the weight of the platform.
G
Yes, it's normal. Mine had a sticker warning not to tighten.
It prevents binding, any backlash that does exist is taken up by the weight of the platform.
This setup in the Z-Axis screw is common to all printers I have seen thus far when using this ballscrew. Do not worry about it.
onap
May 27, 2016, 8:27am
#4
Thanks for your answers. It seems logical to let a freedom degree...