Hello guys… finally my dream house printout is finished. Still not going to finishing process yet and some curling and warping did occurred in the process. Thanks to Julia for assistance, manage to minimise the curling and warping. Maybe I shall re-calibrate the print platform first and apply her solution to make sure no warping and curling in the future print.
Print setting :
0.14 layer height
Solid to Full in-fill
60% fan control (except first floor 0% fan control)
10% support
Print size almost 20 cm x 16 cm. Thus, each floor is printed in two parts.
Looking forward the auto-calibration features in the next software and firmware update
Or manual calibration re-enabled in the next firmware
Hello guys… finally my dream house printout is finished. Still not going to finishing process yet and some curling and warping did occurred in the process. Thanks to Julia for assistance, manage to minimise the curling and warping. Maybe I shall re-calibrate the print platform first and apply her solution to make sure no warping and curling in the future print.
Print setting :
0.14 layer height
Solid to Full in-fill
60% fan control (except first floor 0% fan control)
10% support
Print size almost 20 cm x 16 cm. Thus, each floor is printed in two parts.
Looking forward the auto-calibration features in the next software and firmware update
Or manual calibration re-enabled in the next firmware
Are you going to print a little family to live in it too :)?
[quote name=petrusyap]Hello guys… finally my dream house printout is finished. Still not going to finishing process yet and some curling and warping did occurred in the process. Thanks to Julia for assistance, manage to minimise the curling and warping. Maybe I shall re-calibrate the print platform first and apply her solution to make sure no warping and curling in the future print.
Print setting :
0.14 layer height
Solid to Full in-fill
60% fan control (except first floor 0% fan control)
10% support
Print size almost 20 cm x 16 cm. Thus, each floor is printed in two parts.
Looking forward the auto-calibration features in the next software and firmware update
Or manual calibration re-enabled in the next firmware
Are you going to print a little family to live in it too :)?
[quote name=petrusyap]Hello guys… finally my dream house printout is finished. Still not going to finishing process yet and some curling and warping did occurred in the process. Thanks to Julia for assistance, manage to minimise the curling and warping. Maybe I shall re-calibrate the print platform first and apply her solution to make sure no warping and curling in the future print.
Print setting :
0.14 layer height
Solid to Full in-fill
60% fan control (except first floor 0% fan control)
10% support
Print size almost 20 cm x 16 cm. Thus, each floor is printed in two parts.
Looking forward the auto-calibration features in the next software and firmware update
Or manual calibration re-enabled in the next firmware