Higuys,
excuse me but I need an explanation… :rolleyes: :rolleyes: Who explained me how it affects and when use the command “additional fan speed” in z-software?
Thanks!!!! :) ;)
Higuys,
excuse me but I need an explanation… :rolleyes: :rolleyes: Who explained me how it affects and when use the command “additional fan speed” in z-software?
Thanks!!!! :) ;)
It increases the air flow over the print. Good for small prints or ones that have difficult support. I use 20% for most prints.
Keep in mind that airflow will also weaken the part, and can cause splitting and warping also. Always a trade off.
Thanks… Now I understand! 😉😉