Firmware: sleep mode

I have seen that in the new version of the firmware 1.0.6 when the printer goes to sleep on can you turn off the lights, can you add the fan speed reduction below the printer to make it silent?

PS: translation through Google Translator.

I have seen that in the new version of the firmware 1.0.6 when the printer goes to sleep on can you turn off the lights, can you add the fan speed reduction below the printer to make it silent?

PS: translation through Google Translator.

Both extruder fans are turning off right after going into standby mode

Sorry I probably explained to you badly, I meant the fan that cools the electronic card under the printer.

There are two fans in the base of the printer - one in the bottom plate for cooling the motherboard (quiet) and one in the power supply (noisy). I don't think either one is able to be controlled by software.

Maybe for the next M200/300 HW reversion Z could think about change to a PS with standby mode like PC PS's have that for years.

There are two fans in the base of the printer - one in the bottom plate for cooling the motherboard (quiet) and one in the power supply (noisy). I don't think either one is able to be controlled by software.

Yea, we cannot control that from FW level