woauw !!!

Zortrax give us an offical Gcode converter…

But because there is a but…

What about the good gcode start , gcode end an extruder parameter for example Cura???

If I look to Prusa they give all the steps and parameters to configure Cura for a Prusa printer.

Zortrax just put a Gcode converter with a text file of 3 lines and nothing else.

Very disapointed one more time.

I’m thinking about replace all of them.

Doesn’t work … no material comes from hotend… with zsuite no problem… the same story every time… sad