Heating extruder jumping at 100% back to 62% (firmware v0.0.7)

Richard · September 13, 2015, 8:45pm

Today i noticed that during the heating extruder process when it arrived at 100% the led color changed for a second to white and got red again and than it jumped back to 62% to continue heating op again and started the print.

Happend twice sofar wit the latest firmware.

**** See this post as not posted, I have misread the status in control display . what i saw was the switch from heating pleatform to heating extruder, sorry ****

sappas · September 13, 2015, 10:22pm

There is no problem, it was two diffÃ©rent heating, extruder and plateform, be carefull of reading Zortrax control panel

VipeR · September 14, 2015, 3:19pm

Probably some problem with extruder ribbon.

Richard · September 16, 2015, 4:36pm

There is no problem, it was two diffÃ©rent heating, extruder and plateform, be carefull of reading Zortrax control panel

I was doing zombie shifts at work and i think i might (99.9%) have misread the control panel display. :)

sappas · September 16, 2015, 9:09pm

No problem, we’re only human !