Help Slicing a Project

I successfully sliced this file yesterday, but had to make some changes to the settings.  Now every time I try to slice it I get an error at 100% and it doesn't complete the slice.  It takes about an hour to get to 100%.  I think my computer is just too slow to complete it.  If anybody could please attempt to slice this for me with the Z-ULTRAT settings shown in the photo I would be so thankful!  This is for a customer and they are starting to lose their patience.  Posting here was a last resort. Thank you in advance!

rsjkSHt.png

I think it would make more sense to post the STL model as this is probably where the problem is?

I just attempted it, throws an error at 100% (version 1.5.0.2). Agree with deadbeef.

I tried it a 0.09 and it sliced. See attached. Print is 14hr though

I tried it a 0.09 and it sliced. See attached. Print is 14hr though

Thank you CPS!  I really appreciate it.  Sorry for the late reply, today was hectic.  I'll print this 0.09mm version.  Thanks again!

Thank you CPS!  I really appreciate it.  Sorry for the late reply, today was hectic.  I'll print this 0.09mm version.  Thanks again!

No problem, hope it goes well.