Can we get an option to go up to .3mm height on the Inventure? Currently the only settings available are 0.15 and 0.2. In my mind a range from 0.1 to 0.3 would be ideal to allow users to decide if they want a high detailed print or just something quick to do a form/fit test. At a minimum having the 0.3 in addition to 0.2 would take a 10 hour print down to about 6.5 hours. That could be the difference between having a piece completed in the same work day or needing to wait until the next day
Not sure if the hardware would support this though
Also some other slicers have options for dynamic layer heights. This would be a welcome addition as well