Iphone cord fix

3D Printing Printroom
#1

I was afraid this might be too small of a print but it did a nice job. I printed it laying flat and standing up and I really couldn’t tell the difference.

https://lh5.googleusercontent.com/-a9aACDqtd_M/UyUopDNFupI/AAAAAAAAALw/N7WvQ48mfVo/w916-h1220-no/IMG_3942.jpg

https://lh4.googleusercontent.com/-PsmhBVgEZFQ/UyUopo9EciI/AAAAAAAAAL0/WPCgNLdHJC0/w916-h1220-no/IMG_3940.jpg

https://lh5.googleusercontent.com/-LPxxS45_g1M/UyUoqIp_SVI/AAAAAAAAAL8/ACi74Z2wzg0/w916-h1220-no/IMG_3941.jpg

The shiny stuff in the pic is glue to make sure it holds tightly to the end of the cord.

Cheers!

#2

I was afraid this might be too small of a print but it did a nice job. I printed it laying flat and standing up and I really couldn’t tell the difference.

https://lh5.googleusercontent.com/-a9aACDqtd_M/UyUopDNFupI/AAAAAAAAALw/N7WvQ48mfVo/w916-h1220-no/IMG_3942.jpg

https://lh4.googleusercontent.com/-PsmhBVgEZFQ/UyUopo9EciI/AAAAAAAAAL0/WPCgNLdHJC0/w916-h1220-no/IMG_3940.jpg

https://lh5.googleusercontent.com/-LPxxS45_g1M/UyUoqIp_SVI/AAAAAAAAAL8/ACi74Z2wzg0/w916-h1220-no/IMG_3941.jpg

The shiny stuff in the pic is glue to make sure it holds tightly to the end of the cord.

Cheers!

#3

A practical use nice.

#4

A practical use nice.