Dear users,
firmware 2.5.6 has been released. Full changelog available below:
M Plus Series:
- Fixed an issue where Blackout Response System would not properly react,
- Fixed an issue where the hotend would overheat in malfunctioning devices,
- Fixed an issue where, in some cases, the screensaver would show unset time left after resuming prints after a blackout,
- Fixed an issue where printers would not go back to the main menu from the files list view after removing the pendrive,
- Fixed an issue where files would sometimes not be visible after being uploaded,
- Fixed an issue where printers would display wrong data on remaining storage (inCloud).
M300 Dual and Endureal:
- Added support for camera preview in inCloud,
- Fixed an issue where, in some cases, the screensaver would show unset time left after resuming prints after a blackout,
- Fixed an issue where printers would not go back to the main menu from the files list view after removing the pendrive,
- Fixed an issue where files would sometimes not be visible after being uploaded,
- Fixed an issue where printers would display wrong data on remaining storage (inCloud).
As always - you can download the firmware here .