[M SERIES PLUS / M300 DUAL / ENDUREAL] 2.7.3 firmware release

We are pleased to announce the release of Firmware 2.7.3!

You can download it from downloads section of the support center .
Direct links: M200 Plus , M300 Plus , M300 Dual , Endureal

Changelog available below:

  • Fixed bug that caused loss of communication between the motherboard and the GUI during gcode printing.
  • Fixed bug that prevented the chamber from heating to 200°C for Endureal.

More about this version:

This update addresses issue that caused the printer to stop printing and display a “Communication with GUI lost” error. The problem was most commonly observed when printing G-code files containing a high number of short segments executed in rapid succession.

Additionally, this update fixes a bug in the PID controller that prevented the chamber from reaching 200°C on the Endureal printer.

As always, we welcome your feedback and insights to continue improving.