More Outer perimeters(Layers)

Zortrax M200 General Discussion
1

New here, so sorry if this has been asked before, could not find it anywhere.

Is there an option somehow to create more outer Layers when printing. Many of the prints are relatively weak, and it would be very nice to be able to add more outer perimeters when needed.

I think it would be a great addition to the manual print setup, as you can select top and bottom layers, you could also select outer layers, maybe 3-10 or even 3-15 layers for really strong prints.

Thanks for any advice.

2

I would love to see this as well! Helpful for when tapping holes in my case.

3

Yes, same here. And if I'm not going off topic too much, the option to print the inner layer/s before the outer most as I believe this might help with better quality overhangs.