New z suite - using more filament on model?

Support&troubleshooting Zortrax M200 Plus
1

Hi,

I've printing the exact same model with a different z-suite and it's using more filament than before (adding another 4+hours)

2

Cannot reproduce. On the ABS-based filament profile I get a minor difference, but not as obvious as the one you got on your model.

Could you send me both zcodex files?

3

hmmm... prefer not to give this model out...

Anyways it's a bit strange. it was from 2.7.0 to 2.7.3.

4

hmmm... prefer not to give this model out...

Anyways it's a bit strange. it was from 2.7.0 to 2.7.3.

Ok. I'll try to reproduce this with a different model.