Hi everyone,
I have some problems printing with Z-PLA Pro!
I know there's another topic with kind of the same problem, but I'm using original Z-PLA Pro with the PLA Pro profile!
So when I start printing, the filament comes out very low! Not only at the beginning while printing the "basement", it's permanantly and the extruder is "clicking".
I had this problem with other filaments too, mostly the reason was the heatplate leveled not correctly - but not in this case. It's the same when I load the PLA Pro, it comes out much thinner than other filaments.
I use a brand new perfect clean nozzle!
So what should I do?