Raft optimization

Havent tested any raft settings so far. Would someone be so nice and share his experience on that ? Like less Layers or even no raft at all etc…

thx in advance !


I have experimented and have found the stock setting to be the most reliable. I’ve not had a raft failure using the stock settings. I’ve had raft failures trying to get cute and save time/material.

I also prefer to remove my model from the raft while the raft is still attached. For me the default settings work well for this too.

I’m trying to print without the raft but I have a lot of problems beacuse I cannot find the right z offset.