request layer setting 0.3-0.5

I enjoy the 0.19mm and 0.14mm setting very much. However, sometimes I need not printing in such a detail output. I would rather have a rough 0.3mm or even 0.5mm, which I can see the draft printout in a shorter time.

I also notice there is a gray-out speed setting: normal and high. Will they be available in the coming new version?

Thanks again to all hard-working staff in Zortrax and all the beta tester. :slight_smile:

I believe the thickest layer will be .4mm according to the Zortrax brochure.