Robotto by Zortrax

3D Printing Printroom
#1

Hi :)

http://www.thingiverse.com/make:79580

photo_preview_featured.jpg

Filament: 

Cool Grey Z-ABS

Printing Parameters: 

Layer Height: 0,14mm 

Infill: Light 

Support: 10°

Fan: 20%

Foto hight resolution :

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2003%2024.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2003%2033.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2003%2040.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2003%2048.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2004%2032.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2030.05.2014%2C%2021%2010%2033.jpg

https://dl.dropboxusercontent.com/u/19671723/Zortrax/Robotto/Zdj%C4%99cie%2031.05.2014%2C%2009%2029%2026.jpg

#2

Nice print Pioo!

#3

Nice print! I think I see several splits, though…wonder if you need 0% fan…or maybe an enclosure…

#4

Yes … splits are a big problem. I work all the time how to get rid of them :(

Look:

Zdj%C4%99cie%2031.05.2014%2C%2009%2029%2

This NEW print is with fan speed = 0%. But I also change infill from light to medium :)

:(

Zdj%C4%99cie%2031.05.2014%2C%2009%2026%2

#5

What is the ambient temperature around the printer? Do you enclose your print area? Also try full infill with 0% fan on the robot… that should help to stabilize the walls.