another try to use the M200 for architectural models, in general I am quite pleased with the result, the terrain looks a little weird because of the stepping (a very slight angle -> hard to print) maybe tilting the terrain by 20 degrees would have helped that but that would have doubled the print time ...
slowly I am becoming familiar with the M200 :-)
best
Andreas
Awesome Andreas!
another try to use the M200 for architectural models, in general I am quite pleased with the result, the terrain looks a little weird because of the stepping (a very slight angle -> hard to print) maybe tilting the terrain by 20 degrees would have helped that but that would have doubled the print time ...
slowly I am becoming familiar with the M200 :-)
best
Andreas
Well done!
How big is the model?
Awesome, do you use any supprtos?
Hello guys,
it is about 12,5 X 8,5 cm and 5 cm in height. It was printed in 3 pieces, airbrushed and glued together. The white House was printed with support (10 deg) the rest was printed without support in blue z-ultrat (cant wait for grey z-ultrat...) and 0.09 mm layer.
best