Support material in mid air on z-suite

Z-SUITE/Firmware Troubleshooting
#1

Can somebody tell me if this is normal before I begin my print? It seems like its going to print material onto nothing and end up stringing all over the place..

#2

Can somebody tell me if this is normal before I begin my print? It seems like its going to print material onto nothing and end up stringing all over the place..

What settings you used?

BR,

Rafal

#3

solid fill. 30 degree support. 0% fan

#4

Ive already started the print so we will see in a couple of hours

#5

Layer thickness 0.29 or 0.39 ?