Unable to check model parst thickness before printing anymore

Z-SUITE/Firmware Troubleshooting
1

Hello there,
In the old versions of ZSuite, for Zortrax M200 Plus, it checked my models parts thickness (in green color) before setting it to print.

It don’t seem to do it anymore.
In the old versions (2.7.0) it was during the analysis step.

Is there any reason ?

Thanks in advance.

2

Hey there! Thin walls analysis is now available in Print settings step. Please, see the picture attached :slight_smile:

obraz
obraz1918×956 60.7 KB

3

Hello Marta,

Thanks you a lot really. I didn’t notice it °_°

Kind regards.