v2 hotend ??

Z-SUITE/Firmware General Discussion
#1

I am wondering if i should upgrade to the v2 hotend.

i dont have any problems with v1 end .

has anyone been sucsessful printing z-glass with the v1 end ?

#2

Hello there buster20

We strongly recommend hotend V2 for printing with Z-Glass.

#3

i never had any problems with v1 and zglass but this is not the rule and i must have printed not more than 2 rolls and mostly small prints

you can stay with v1 if you rarely print in zglass, but if you need anything demanding in this material then v2 is your friend

#4

i never had any problems with v1 and zglass but this is not the rule and i must have printed not more than 2 rolls and mostly small prints

you can stay with v1 if you rarely print in zglass, but if you need anything demanding in this material then v2 is your friend

Yeah. Some don't have any issues with V1 and Zglass. I, for one, had an issue.

My V1 wouldn't print Zglass. I think I was able to get one small print out of it and that wasn't even complete.

But when I reamed out the V1 hot end it printed nice, but the V2 printed perfectly.

#5

thanks guys