Z-Lift feature isn't available in my Z-Suite update

Z-SUITE/Firmware General Discussion
#1

I uninstalled and re-installed twice. Am I just not seeing it?0hn7i4D.png

#2

I think it might be automatic.. I don't see it on mine either.... Hmmm... It says added option. Mine looks just like yours..

#3

I think it might be automatic.. I don't see it on mine either.... Hmmm... It says added option. Mine looks just like yours..

I thought it might be automatic, but my nozzle is scraping the top of my print as it travels as we speak.

#4

Mine is like your... no option...

#5

Ok.. I asked Rafal about Z lift. He said it's automatic. I just confirmed this on my current print. It does drop Z a slight amount when printing holes in a flat surface. We'll see how it acts on the top surface..

#6

Thanks Kyle!

#7

Thanks for asking!  How were the tops of your print?  Mine are still scraping.

#8

The top looks good on my prints but it usually looked good before too.

#9

Thanks for asking!  How were the tops of your print?  Mine are still scraping.

No scrapes..