Z-Suite 1.0, Mac, offsets text box not big enough to display text

Z-SUITE/Firmware General Discussion
1

In the new version, if I enter 0.04 and 0.14 for offsets in the advanced dialog, the text box for entry is not big enough to see the characters. Is it intended only to be accurate to 0.1mm? If so why take more than two digits? Experience suggests it is accurate to 0.01mm.

Tried putting this in the bug tracker but the post new topic button is dead.

1311

2

OK, managed to get that into the bug tracker. It requires both an stl file and a zcode file, even if the bug is with Z-Suite and independent of model.