Z suite bug? Or hardware issue.

Z-SUITE/Firmware Troubleshooting
1

Team

I have been building several parts since I got the machine.

Recently in V0.08 I found this issue with seams, but the same parts same settings on  0.07 came out perfect. Please advice

Part with V8 code

[URL=http://s1242.photobucket.com/user/mmaxds/media/DSCN2987_zps1d10eab0.jpg.html]DSCN2987_zps1d10eab0.jpg[/URL]

[URL=http://s1242.photobucket.com/user/mmaxds/media/DSCN2985_zps7781e010.jpg.html]DSCN2985_zps7781e010.jpg[/URL]

Part with V7 code

[URL=http://s1242.photobucket.com/user/mmaxds/media/DSCN2986_zpsaf8c68ab.jpg.html]DSCN2986_zpsaf8c68ab.jpg[/URL]

[URL=http://s1242.photobucket.com/user/mmaxds/media/DSCN2984_zpsa4872072.jpg.html]DSCN2984_zpsa4872072.jpg[/URL]

Second Problem, On the simulation part looks good and with a nice infill, but in the Physical world it doesn't..

Example here, How much can I thrust in what the software tells me the machine is going to do? If this is no useful information, some parts can came out very unusable.

Code in zsuite

[URL=http://s1242.photobucket.com/user/mmaxds/media/toolpath_zps4cc37d28.png.html]toolpath_zps4cc37d28.png[/URL]

Real part.

[URL=http://s1242.photobucket.com/user/mmaxds/media/DSCN3070_zpsb870491e.jpg.html]DSCN3070_zpsb870491e.jpg[/URL]

As you can see there is a huge gap where definitely fits the 0.4mm diameter filament extruded, but for some reason is not there as it looks on the software.

2

Did you use the offsets at all?

3

No, no offsets. Part Interacts with some others and for orientation that could give me fitting problems.

I printed the part on the up mini and it came out nice. Of course lifted from the bed <_<

4

I saw it now, too. I agree…this needs some tweaking for 0.0.9

5

No, no offsets. Part Interacts with some others and for orientation that could give me fitting problems.

I printed the part on the up mini and it came out nice. Of course lifted from the bed <_<

No, no offsets. Part Interacts with some others and for orientation that could give me fitting problems.

I printed the part on the up mini and it came out nice. Of course lifted from the bed <_<

Do you use the elmers purple disappearing glue?

6

Nope, I always rely on a good calibration. I fact it was a little low I am reprinting now to see how it comes out. It will be a real shame for zortrax to get this part done better on the mini....