Z-Suite - External LCD Printer layer support

Z-SUITE/Firmware
#1

Hello,
In Z-Suite, it appears that if you configure/use an ‘External LCD Printer’ for a project, you only get the choice using 0.05 Layer Thickness in the print settings - there is no option for 0.1, 0.025, etc…
Is this by design, or am I missing something?
Thanks,
Rich.

#2

Hi, @RichWP.

At the moment only 0.05 layer is available.

#3

Thanks for the reply! I understand that it’s probably not a priority, but I would vote for support for other layer heights for external LCD printers in a future release.