Pass me some models you'd like to see so I can print them for you. :)
Any chance you can print this; is it possible ?
I sent you a PM of the File
How's it going with the print? I am ready to buy one. I need to see if it prints that part ok before i hand my cash over.
How big is the wall thickness?
Wolfgang
How's it going with the print? I am ready to buy one. I need to see if it prints that part ok before i hand my cash over.
Enclosed the pictures of your model. It's hard to capture small details, but I tried my best. I'll try to print it again using a thinner layer (this one is printed with 0,1 layer thickness).
How big is the wall thickness?
Wolfgang
The Inkspire builds models out of tiny cuboids, each with a rectangular base 50×50 microns and 25 microns of height.
This is good, exceeded my expectations