Do you think it looks like 0.0.3 because of the seams? I still get seams with 0.0.4 but it’s better than before.
DELETED
Looks GREAT!!!
DELETED
[quote name=pilou74]and here is the Daft Punk helmets :
http://imagizer.imageshack.us/v2/640x480q90/31/pm26.jpg
http://imagizer.imageshack.us/v2/640x480q90/191/c48w.jpg
Really nice prints. Quite difficult to remove support, but it’s ok.
[/quote]
They looked a lot bigger before you stuck your fingers in them… lol… Looks good!!
DELETED
DELETED
Pilou, where did you find Daftpunk helmet models ? I’ve already printed the one of the printroom, but I would like the other one.
Ted
Here :
http://www.thingiverse.com/thing:95504/#files
and here :
http://www.thingiverse.com/thing:94603/#files
DELETED
[quote name=pilou74]Print of today !
Amazed of the quality ! No support, 0.19mm layer, no filling… amazing print. 14 minutes.
[/quote]
Pilou, can we see that a little more close-up and higher resolution? Merci!
DELETED
Pretty cool for no support at all!
oh yes ! I’m surprised. I will print it much bigger, now, just to see how it will look. But it should be amazing. Maybe in another color… What do you think ?
Be nice to see the bigger version. It’s those type of structures that I’ll be wanting to print, so how the Zortrax manges small, fine overhangs - with or without support, is of interest.
Thanks Pilou for the helmets 
DELETED by Pilou74
DELETED by Pilou74
Your platform is not placed correctly/or calibration knobs is loosen too much, platform do not sitting fully on the pegs (visible on the picture).
DELETED by Pilou74