Third-party PETG filaments

[kasilov]

Good afternoon friends!
Someone uses third-party PETG filaments?
Successfully?
Tell me please what settings you use and what difficulties when printing!
I use microswiss

thank you!

[Zoltan]

There is a thread about this topic, if you are still interested.

More Z-PETG problems

Back in July I had lots of problems with a Z-PETG model that printed OK the first couple of times, then failed horribly after that. I posted here about it. Eventually I replaced the nozzle, went back to printing Z-ABS and Z-ULTRAT and everything has been fine since. Yesterday I tried to print another of the same Z-PETG model and immediately had similar problems recur. On the first print the nozzle was far too close to the bed - while printing the first layer of the raft almost no material at …