Z-SUITE 4.0.0 BETA

[robysoldtamiya]

Hi
please read my discussion about the same question

First layer gap

I would like to better understand the meaning of this option. Default option is set to 0,21mm In this first layer is the blue parts raised by 0,21mm and grey not ? [1st%20layer%20gap%201] after some layers we come to this point again is blue parts raised by 0,21mm and grey not ? [1st%20layer%20gap%202] Thank Roby

I tried pa12 on my m200, I printed a simple flat spur gear but it will always warp